PURE POLYUREA

100% pure polyurea, two component suitable for waterproofing, protection and sealing in general,
It was developed as a sprayable aromatic coating. Aromatic, continuous, high intensity,
using special spraying equipment to create a solid and elastic pure polyurea membrane
consists of two highly reactive liquid components, isocyanates and amines mixed, high mechanical and chemical
It has resistance properties.

Product Features:

Product description

100% pure polyurea, generally two-component suitable for waterproofing, protection and sealing,
It was developed as a sprayable aromatic coating. Aromatic, continuous, high intensity,
using special spraying equipment to create a solid and elastic pure polyurea membrane
consists of two highly reactive liquid components, isocyanates and amines mixed, high mechanical and chemical
It has resistance properties.

Use

For waterproofing and protection of:

• ROOF: Inclined and flat roofs (walkable), balconies and ledges.
FLOOR COVERING: Parking lots with heavy traffic, waterproofing and abrasion resistant
industrial floor surfaces with requirements
BRIDGE DECK: paving concrete elements of civil engineering under asphalt
• Tanks and irrigation channels, drinking water contact
Retaining walls and foundations
Green roofs and walls
Power plants, recycling, water waste, water treatment and petrochemical facilities
• Swimming pools, aquariums, lakes. Near sea water
Vehicle and boat covers (bed liners)
• Rehabilitation of asbestos roofs
As a protection for spray polyurethane foam
Defense Industry

Application:

In general, you should take the following factors:

• Repair the surface (fill in recesses, remove unevenness, remove old waterproofing, etc.)
Single point preparation (perimeter, pools / drains, expansion joints or structural)
• Clean the surface or substrate by removing any dust, dirt, oil or bloom.
• Remove silicone-based products
• The surface must have sufficient pressure resistance of the membrane. If it were not so, to this goal
we will continue to apply our primer resins to achieve, for some substrates adhesion
tests may be required.
• In general, all surface preparation, before application, all grease, dirt loose and spilled
requires cleaning of materials.
Pure polyurea system can be applied to many different surfaces and depending on the nature or condition of the process.
will vary. Below is for the most common surfaces
We have listed some of the applications; Other not disclosed
Please contact our technical department for surfaces.
Concrete surface: concrete must be fully cured (concrete curing takes 28 days) or any
however, depending on the primer used, the allowable
the maximum moisture level should be verified. any concrete
delay or release agent should be eliminated and sand
obtain an open-pore surface by spraying, milling or sandblasting
should be. Any cracked and damaged area can avoid our epoxy resin.
It must be repaired using an epoxy mortar by mixing it with silica.

Packaging and Consumption:

450 kg Barrel In Sets